Installation of SuperSense GasCheck

The installation of a SuperSense GasCheck sensor is very easy and can be done in a few steps.

1. Removing an existing fuel gauge
   If an existing fuel gauge is installed, it can be removed by loosening the two small screws. Since there is no mechanical connection to the inside of the tank, the removal can also be carried out with a filled tank. Please be careful not to loosen the four large screws. If necessary, consult the manufacturer's instructions for your tank if you are not sure.
   
   
   
   
2. Mounting the GasCheck sensor head
   The SuperSense GasCheck sensor head is mounted in the same location as the fuel gauge and secured with the original screws. Note: There is a notch on the sensor head, please note that this notch must be in the same place as the original fuel gauge.
   
   
   
   
3. Connecting the cable from the GasCheck control box
   Plug the connection cable supplied into the connection provided and fit the protective sleeve so that the connection is resistant to the weather.
   
   
   
   
4. Settings on the app
   For the wired version:
   If you are already using the app (e.g. with the SuperSense Bluetooth box), simply plug the cable of the GasCheck control box into a free port of the Bluetooth box. The tank will then automatically appear as an additional tank in your app and can be freely configured.
   
   For the wireless version:
   If you are using our sensor "SS-GC-XX-W", i.e. in the wireless version, then connect the power supply with the supplied cable and use the device management within the SuperSense app to connect the device.
   
   In the tank settings you can now select "Gas Tank" as tank type and customize it according to your personal needs.

General notes:

• SuperSense always calculates in a logic range of 0 - 100% (and not 5 - 80% like standard fuel gauges). That means:
• In SuperSense 0% = empty tank and 100% = maximum filling. Example: If you have a 120 litre gas tank, it can usually only be filled to 80%, i.e. 96 litres. These 96 litres correspond in the "SuperSense logic" to 100%, i.e. "full". In the app, this value (96 liters) must also be entered for the fill level and not 120 liters.

Important:

• SuperSense GasCheck is factory calibrated and does not need to be adapted to the tank. Do not change the calibration of the sensors without good reason.